Skip to content
Matthews
Drywall Repair

(980) 577-1280Call 7 days, 7am–9pm

Repair page

Corner Bead Repair in Matthews, NC

Corner bead repair in Matthews comes up in nearly every busy house. An outside corner is the one part of a wall that takes direct hits from vacuum cleaners, moving boxes and strollers, and the strip of bead under the compound dents, cracks or comes loose long before the flat wall around it shows any wear.

What breaks an outside corner

Most corners in houses of the 1980s and later are finished with metal bead nailed or crimped on, or with paper-faced bead set in compound. A sharp knock bends metal bead inward and cracks the mud over it. Paper-faced bead can tear or peel at the edge. A long vertical crack along a corner, with no dent, often means the bead has worked loose from the framing and is moving each time it is bumped.

Corner bead, in plain terms

Can a small dent in a corner just be filled?

A shallow ding where the bead is still straight and tight can be filled and sanded. If the bead is bent, cracked or moves when you press it, filling it only buys a few months; that length needs new bead.

Metal or paper-faced bead: which goes back on?

Usually whatever is already there, so the new length matches the profile of the old. Paper-faced bead is a common choice in high-traffic spots because it resists cracking from knocks.

Will the new section line up with the rest of the corner?

It should. The new bead is set with a level against the sound corner above and below, and the coats are feathered out on both faces so the edge reads as one straight line.

Rebuilding a corner, start to finish

The damaged length is scored and cut out back to sound bead, usually from just below the dent to a little above it. New bead is fitted, checked with a level so it lines up with the corner above and below, and fastened. Then come three coats of compound on each face, each one dried before the next, and a light sanding with a vacuum attached. Texture is blended onto both faces before primer, because a corner is seen from two directions and an untextured face shows immediately.

Matthews stairwells, hallways and open rooms

With most houses in Matthews dating from the 1980s on, two common layouts produce most of the corner work we see: stairwells with long outside corners at the landing, and open living areas where a half-wall or a kitchen peninsula ends in a corner right at hip height. Both get bumped constantly. Older houses near the railroad-era downtown may have plaster corners instead, which need a different approach, so say so on the phone.

Move-outs are another source. Furniture carried down a stairwell crushes more corners than anything else, and a corner fixed before a rental hand-back or a listing photo shoot is one of the cheapest ways to make a room look cared for. In humid summer weather, compound takes longer to dry, so leave room in the schedule before painters arrive.

How a corner job is priced

Length of the damage, the number of corners, height and access, the kind of bead and the texture all count. A single dented corner at waist height is a small job; a two-story stairwell corner needs more setup and more time. Bundling corners with other dents and holes in the same house keeps it to fewer trips.

Have this corner bead repair priced

Call, send a photo or use the quote form. Describe where the damage is and how long it has been there.

Calling gets the wall looked at and priced by a drywall pro who works around Matthews.

Call 7 days, 7am–9pm

Tap to callShare a photo