Skip to content
Matthews
Drywall Repair

(980) 577-1280Call 7 days, 7am–9pm

Repair page

Drywall Hole and Dent Repair in Matthews, NC

Drywall hole and dent repair in Matthews covers the everyday damage a lived-in house collects: a doorknob driven through the wall, a dent from a dresser, the torn holes a TV mount leaves behind. The size of the hole decides the method, and the texture around it decides whether anyone will ever spot the patch.

Hole sizes and the patch each one needs

Small stuff: anchor tears, pinholes, shallow dings

Small damage gets filled directly. Torn paper around an anchor is cut back and sealed first, because compound over loose paper bubbles. A shallow dent takes two or three thin coats.

Doorknob-size holes

Holes up to a few inches across need something behind them. The usual method is a backed patch: a piece of drywall cut to fit, with a strip of wood or a clip behind the opening to screw into, then tape and coats. A stick-on mesh patch works for the smallest of these but tends to show as a slight bump once painted.

Holes bigger than your hand

Large damage is cut back to a neat rectangle reaching the studs on each side, so the new piece can be screwed to the framing. The seams are taped like any other joint and finished in three coats, spread over more than one visit when the drying calls for it.

  • Smooth
  • Orange peel
  • Knockdown
  • Skip trowel
  • Popcorn
Common wall and ceiling textures. The patch is finished in whichever one the room already has.

Before anything is cut: power, pipes and dust

Every hole gets checked for what is behind it before the opening is enlarged. Wiring often runs horizontally at outlet height and vertically beside switches, and walls behind bathrooms and kitchens can carry supply and drain lines. The circuit is shut off at the panel when the cut is near anything electrical. Cutting is done with a hand saw rather than a power tool where the space behind is unknown.

Dust is handled the same careful way: furniture moved or covered, floors protected, a plastic barrier around the work in a lived-in room, and the HVAC return covered while sanding. If the house was built before 1978, the EPA notes that repair work disturbing painted surfaces can create lead dust, so the paint around a hole in an older house should be tested before it is sanded.

Holes in a busy Matthews household

Matthews is a town of about 29,400 people and roughly 12,000 homes, most of them built from the 1980s on, which means a lot of interior doors on their original hardware and a lot of walls that have seen a few moves. The same doorknob going through the same spot twice is common. A doorstop on the baseboard or a hinge-pin stop is worth adding once the wall is fixed.

Hot, humid Piedmont summers slow drying on any patch that needs several coats, so a repair scheduled for July may take an extra day between coats compared with the same patch in a dry October. That matters most before a move-out or a listing, when painters are booked behind the drywall work.

What changes the cost of a patch

Size, the number of holes, whether new board and backing are needed, texture and paint. A dozen small anchor holes may cost less than one doorknob hole because they need no backing. A ceiling hole costs more than the same hole in a wall, because of ladders, gravity and dust.

Hole and dent questions from Matthews

Does a doorknob hole mean a new sheet of drywall?

Yes. A backed patch cut to fit the hole is the normal repair. Replacing a full sheet is only needed when the damage is large, wet or spread across much of the wall.

Will I see the patch after it is painted?

Not if the coats are feathered wide, the texture follows the wall around it and the patch is primed before paint. Skipped primer is what usually turns a patch into a dull square.

What keeps the same door from going through the wall again?

A doorstop. A baseboard stop or one on the hinge pin is a small addition once the wall is repaired.

How soon can a patched wall be painted?

Once the final coat and primer are fully dry. That depends on humidity and the compound used, and the pro will tell you when it is safe to paint.

Can small jobs like one hole be booked?

Yes. A single hole is a normal request. If there are other dents or pops in the house, mentioning them on the call lets them be handled in the same visit.

Have this hole and dent repair priced

Call, send a photo or use the quote form. Describe where the damage is and how long it has been there.

Calling gets the wall looked at and priced by a drywall pro who works around Matthews.

Call 7 days, 7am–9pm

Tap to callShare a photo